“The following is a brief summary of the steps required in a typical installation of the Radix track and ski assemblies on an off-road motorcycle. Estimated time (for Steps 2-5 below) for installing the fully-assembled Radix track and ski assemblies on the motorcycle is approximately 1-2 hours for the experienced motorcycle ‘wrencher’. More detailed installation instructions, specifications and tips can be found in the Radix Owner’s Manual delivered with each Radix kit.

 

	Step One:    Preparation and Setup
	Step Two:    Removal of the motorcycle rear tire, shock, swingarm and airbox.
	Step Three:  Mount the track assembly to the motorcycle
	Step Four:    Remove the motorcycle front wheel, fender and brake
	Step Five:     Install the ski assembly on the motorcycle fork
	Final Step:    Do a final check of the snowbike, fill the tank and go snowbiking!
	Reverse Changeover:    From snowbike back to motorcycle